The 8306 Log Detector Module has a dual function. It is used as a detector to convert RF power to DC voltage (RSSI). And, it is used as a high gain, RF limited amplifier.
The module has an input impedance of 50 ohms (J1) and a bandwidth of 3 MHz to 160 MHz.
The RSSI dynamic range is -90 dBm to +10 dBm, with a DC output of +0.4 volts to +2.4 volts, on J2, "MAGVOLTS". The Limited I.F. Output (J3) is a 50 ohm source with 50 mv peak to peak output.
The limiter input dynamic range is from -77 dBm to +10 dBm.
 |
| Log Detector Rev 0 |
Build process
So far the Log Detector was one of the easiest modules to solder.
So far the Log Detector was one of the easiest modules to solder.
The only problem was to get hold of T1 but fortunately Coilcraft was kind enough to send me two pieces.
Once the module is thoroughly tested and confirmed working it is very important to shield this kind of units properly.
Links:
Spectrum analyzer Part I Controller board
Spectrum analyzer Part II Phase Detector
Spectrum analyzer Part III ADC 16
Log Detector Module
No comments:
Post a Comment